Everyone knows that gears are the most widely used general mechanical parts in the transmission system of mechanical equipment. Traditionally, carburizing process and high-frequency surface quenching process are mainly used. Low-carbon steel is used to make the surface of the workpiece wear-resistant. This process has good comprehensive performance, but due to high cost, easy to cause environmental pollution, and inconvenient to process large modulus gears and large gear shafts, it is currently only used in specific industries such as automobiles and tractors. With the continuous improvement of the technology of Pneumatic
Dot Peen Marking Machine, gears are widely used in mechanical equipment and effectively solve the above problems.
Dot Peen And Scribe Marking use advanced 3D dynamic marking technology, which can mark surfaces that are not in the same plane by setting different height distances in the software. Its maximum marking speed of 7000mm/s high-speed galvanometer scanning is suitable for industrial mass production, and it adopts fully enclosed optical path, imported CO2 radio frequency laser, and strict multiple protection control design to ensure the overall stability of the equipment.
1. Fully enclosed maintenance-free laser optical system, no adjustment, ready-to-use, high-precision, high-speed marking/cutting performance, work efficiency is 20% higher than similar models.
2. Original American imported coherent RF laser, high power, good spot quality, stable power, life of more than 20,000 hours.
3. Professional constant temperature circulation industrial cooling water system makes the whole machine run more stable and power consumption lower. Strict multiple protection control design, suitable for a wide range of ambient temperatures, ensures 24-hour continuous and reliable operation of the laser marking system.
